Add 3GPP TS 29.128 V15.6.0 (2019-09) Add Communication-Failure-Information, Grouped, code 4300, section 6.4.4 Add Cause-Type, Unsigned32, code 4301, section 6.4.5 Add S1AP-Cause, Unsigned32, code 4302, section 6.4.6 Add RANAP-Cause, Unsigned32, code 4303, section 6.4.7 Add BSSGP-Cause, Unsigned32, code 4309, section 6.4.8 Add GMM-Cause, Unsigned32, code 4304, section 6.4.9 Add SM-Cause, Unsigned32, code 4305, section 6.4.10 Add Number-Of-UE-Per-Location-Configuration, Grouped, code 4306, section 6.4.11 Add Number-Of-UE-Per-Location-Report, Grouped, code 4307, section 6.4.12 Add UE-Count, Unsigned32, code 4308, section 6.4.13 Add Connection-Action, Unsigned32, code 4314, section 6.4.18 Add Non-IP-Data, OctetString, code 4315, section 6.4.19 Add Serving-PLMN-Rate-Control, Grouped, code 4310, section 6.4.21 Add Uplink-Rate-Limit, Unsigned32, code 4311, section 6.4.23 Add Downlink-Rate-Limit, Unsigned32, code 4312, section 6.4.22 Add Extended-PCO, OctetString, code 4313, section 6.4.26 Add SCEF-Wait-Time, Time, code 4316, section 6.4.24 Add CMR-Flags, Unsigned32, code 4317, section 6.4.25 Add RRC-Cause-Counter, Grouped, code 4318, section 6.4.27 Add Counter-Value, Unsigned32, code 4319, section 6.4.28 Add RRC-Counter-Timestamp, Time, code 4320, section 6.4.29 Add TDA-Flags, Unsigned32, code 4321, section 6.4.31 Add Idle-Status-Indication, Grouped, code 4322, section 6.4.32 Add Idle-Status-Timestamp, Time, code 4323, section 6.4.33 Add Active-Time, Unsigned32, code 4324, section 6.4.34

# Configuration file for the peer whitelist extension.
#
# This extension is meant to allow connection from remote peers, without actively
# maintaining this connection ourselves (as it would be the case by declaring the 
# peer in a ConnectPeer directive).
#
# This extension supports configuration reload at runtime. Send
# signal SIGUSR1 to the process to cause the process to reload its
# config.
#
# The format of this file is very simple. It contains a list of peer names
# separated by spaces or newlines. 
#
# The peer name must be a fqdn. We allow also a special "*" character as the
# first label of the fqdn, to allow all fqdn with the same domain name.
# Example: *.example.net will allow host1.example.net and host2.example.net
#
# At the beginning of a line, the following flags are allowed (case sensitive) -- either or both can appear:
# ALLOW_OLD_TLS : we accept unprotected CER/CEA exchange with Inband-Security-Id = TLS
# ALLOW_IPSEC   : we accept implicitly protected connection with with peer (Inband-Security-Id = IPSec)
# It is specified for example as:
# ALLOW_IPSEC vpn.example.net vpn2.example.net *.vpn.example.net
# These flag take effect from their position, until the end of the line.