Navigation



Version 5 (modified by Administrator, 13 years ago) (diff)

--

Troubleshooting

This page describes a few steps that you can follow in order to better understand a problem you are encountering with freeDiameter.

Gathering debug messages

If your problem occurs following a reproductible sequence of events, you may get useful information by:

  • Compiling the framework with DEBUG support. This is done by building freeDiameter with CMAKE_BUILD_TYPE=Debug option (see Installation for more information).
  • Running the daemon with a higher level of details in the debug output. Default is level 1 : INFO. The level is increased by passing one or more -d flags on the command line. In many cases, -dd or -ddd should give enough feedback to get a precise idea of what is going on. The levels are defined in [source:freeDiameter/include/freeDiameter/libfdproto.h libfdproto.h] as follow:
    • NONE (0) : No message is displayed.
    • INFO (1) : Only important messages and errors are shown. This is the default, but might be overwritten at compilation.
    • FULL (2) : Additional information, allowing to follow the execution.
    • ANNOYING (4) : Very verbose level, including for example loops contents.
    • FCTS (6) : Traces entry inside most framework functions, with their parameters.
    • CALL (9) : Traces almost all function calls.

The levels above 3 will result in a lot of information being displayed, and a slowing of the framework's execution. These must be used with care. To get level 3 for example (assuming default is 1), use:

$ freeDiameterd -dd
  • In addition, if you were able to isolate the function or at least source file where the problem is occurring, you can use --dbg_func=<funcname> or --dbg_file=<filename> to get maximum detailed information in this function/file only. See Usage page for more information on these flags.

It is also of course possible to use a debugger such as gdb with freeDiameter, although its multithreaded design makes it a bit more difficult.

Reporting a problem

Please use the "Search" function of this site first to look for similar reports. This searches both the existing tickets and the mailing-list archives.

If your problem is not already solved, please report to the support mailing-list: help@freediameter.net. If possible, include as much useful information as possible, including:

  • your configuration file -- if relevant, strip / alter any confidential information
  • the debug messages showing the problem
  • the Operating System on which you are running the framework
  • the steps to reproduce the problem.

In some cases, a network capture (realized with wireshark for example) may also be helpful.