diff --git a/target/linux/brcm47xx/base-files/etc/init.d/netconfig b/target/linux/brcm47xx/base-files/etc/init.d/netconfig
index d7839b6..6446483 100755
--- a/target/linux/brcm47xx/base-files/etc/init.d/netconfig
+++ b/target/linux/brcm47xx/base-files/etc/init.d/netconfig
@@ -150,6 +150,30 @@ start() {
 				}
 			}
 		}
+                if (model == "D-Link DIR-330") { # boardtype is 0x0472, so we need to reset the parameters
+		   # The switch is on eth1, this script defaults to switch on eth0, so we write the values directly instead.
+                       print "#### DIR-330: eth1 must be up for configuring the switch "
+                       print "config interface switchport"
+                       print " option ifname \"eth1\""
+                       print " option proto none"
+                       print ""
+		        print "config switch eth1"
+                       print " option enable   1"
+                       print ""
+                       print "config switch_vlan eth1_0"
+                       print " option device   \"eth1\""
+                       print " option vlan     0"
+                       print " option ports    \"0 1 2 3 5t\""
+                       print ""
+                       print "config switch_vlan eth1_1"
+                       print " option device   \"eth1\""
+                       print " option vlan     1"
+                       print " option ports    \"4 5t\""
+                       print ""
+                        c["lan_ifname"] = "eth0.0"
+                        c["wan_ifname"] = "eth0.1"
+                }
+
 		# Buffalo WBR-B11 and Buffalo WBR-G54
 		if (nvram["boardtype"] == "bcm94710ap") {
 			c["vlan0ports"] = "0 1 2 3 4 5u"